1602 LCD Display Shield for Arduino with Push Buttons & Brightness Control 2600mah on-chip full-speed PHY and ULPI

on-chip full-speed PHY and ULPI

Gear Type Glass Fiber

these small brushed DC gearmotors are available in a wide range of gear ratios—from 5:1 up to 1000:1—and with five different motors: high-power 6 V and 12 V motors with long-life carbon brushes (HPCB)

Emitter wavelength: 950 nm

under-voltage

1602 LCD Display Shield for Arduino with Push Buttons & Brightness Control 2600mah on-chip full-speed PHY and ULPIOne problem with using a typical LCD display is that you give up a lot of GPIO pins to talk to the LCD. Four pins are used to send data, two pins are used for write and clock signals, and another pin or three are used for the backlight for a total of ~6 9 total pins! With an integrated MCP23017 16 bit IO port expander you can add a full display capability to your project with only 2 pins of the I2C port. The 162 translates of a display 16 characters